R1200C CHIP INSTALLATION INSTRUCTIONS
Short summary:
The following BMW service manual provides more detailed instruction on bike disassembly. R1200 C 01 51 9 799 959 Electrostatic discharge (ESD) mat and wrist ground strap are highly recommended. EXTERIOR ...
Long summary:
R1200C CHIP INSTALLATION INSTRUCTIONS
TOOLS REQUIRED:
1. 3mm Hex key, ball end preferred;
2. 4mm Hex key, ball end preferred;
3. 5mm Hex key, ball end preferred;
4. #2 Phillips head screwdriver, long;
5. Small flat blade screwdriver, NON-MAGNETIC tip;
6. Medium flat blade screwdriver, suitable for use as pry bar;
7. T30 Torx, tamper-proof;
8. Adjustable fuel flow restriction clamps, qty: 2, refer to photo in step 3;
9. Masking tape: useful for labeling fuel lines, vent hoses, screw locations;
10. Clear RTV silicone;
11. Medium wire ties, qty: 2, for fuel tank vent hoses @ fuel cell;
This instruction set provides a basic task list to follow, though presumes mechanical familiarity and
confidence in disassembly of the bike. The following BMW service manual provides more detailed
instruction on bike disassembly.
R1200 C 01 51 9 799 959
Electrostatic discharge (ESD) mat and wrist ground strap are highly recommended.
EXTERIOR DISASSEMBLY
1. Remove both sets of side covers.
2. Remove front seat (2x 5mm Hex).
3. Remove fuel tank. LESS FUEL IS BETTER.
Clamp off the fuel supply and return hoses at the
plastic fuel pipes. These hoses MUST be clamped
to avoid substantial fuel loss. Some late bikes may
be equipped with a quick-connect fitting (not
shown). Simply depress the spring and pull fittings
apart; push together to reconnect.
- 8926 BROADWAY, STE# 101 * SAN ANTONIO, TX 78217 * V# 210.826.0014* F# 210.822.7808-
info@rhinewestperformance.com www.rhinewestperformance .com
1
CONTROL UNIT REMOVAL
1. The control unit and harness connections
should be visible now that the tank has been
removed. Remove the four Phillips head
control unit mounting screws, as shown.
2. Pull control unit up and off of the E-box
mounting plate. IF you are using an
aftermarket exhaust system, pull off the
black pla ...
Source: www.rhinewestperformance.com
Related
BMW M3 E46 Front Installation Manual, 332 & 355 ST-40 Front Big Brake Upgrade
BMW M3 E46_Front Installation
Manual_98-137-1450_Rev. ... or
difficulties, please contact the StopTech
Customer Service Department ...,
more
BMW M3 E36 Rear Installation Manual, Installation Instructions BMW M3 E36 1995
- 1999 BMW M3 E36_Rear Installation
Manual_98-131-1451_Rev. ... or
difficulties, please contact the StopTech
Customer Service Department on ...,
more
Service Light Reset - BMW (1999 to 2001), Autodiagnos Ltd, 5 Pullman Court, Great
Western Road, Gloucester GL1 3ND
Registered No: 3062855 Service Light Reset
- BMW (1999 to 2001) Certain instrument
clusters require manual ...,
more
