Part 106030 2003-06 Ford Expedition
Short summary:
Part 106030 2003-06 Ford Expedition. Tie rod nut 3 Sway bar nut Support the weight of the spindle so that tension is not placed on the ABS wiring or brake line. A hammer may be needed to break
Long summary:
Ford Expedition Set up truck on a two post lift or jack stands and remove the wheel. Then remove: 1. Upper ball joint nut 2.Tie rod nut 3 Sway bar nut Support the weight of the spindle so that tension is not placed on the ABS wiring or brake line. A hammer may be needed to break the ball joint and tie rod free always wear safety goggles when using a hammer. Remove the drive axle bolts (on 4wd models). The drive axle uses a 12mm twelve point bolt; make sure you use the correct tool. FAILURE TO REMOVE THE DRIVE AXLE WILL MAKE IT VERY DIFFICULT TO REINSTALL THE STRUT ASSEMBLY. Remove the strut and mount it in a bench vise, and then install the Truxxx kit. Torque fasteners to OEM spec. This kit is painted gray for better visibility production kits are black. Reinstall the strut assembly into truck. A prybar may be useful to get the strut reinstalled. Use a tall jack stand to push the lower A-arm up to reinstall the upper ball joint nut. Reinstall the tie rod nut and sway bar nut after the upper ball joint is reattached. Make sure that the all fasteners are torqued properly. Always double-check your work. Check the alignment. During our research and development, we found that the Expedition only needed to have its toe set caster and camber stayed within spec. We recommend that an alignment technician experienced with lifted trucks perform the alignment. Always do an alignment after changing tires on a vehicle. Remember to adjust your headlights after installing the kit Caster Left Caster Right Camber Left Camber Right Toe-in Need Camber Kit? 3 3.5 0 -1/4 -1/32 No Alignment Specifications: Rear Kit installation is almost the same as the front. 1. Remove tie-rod. 2. Remove Strut. 3. Attach Truxxx piece to strut. 4. Reinstall strut. Always double check your work!
Source: www.truxxx.com
Search Terms:
Related
Single-Nozzle Nitrous Kit for Ford Focus Part Number 13098, illustrate. two alternative wiring
arrangements. It should be (See insert -
Diagrams 3 and 4) Diagram three.
exemplifies the minimum require- ment.
suggestions include running it under
the carpet, under the kick-panel moldings,
or
under the floor panel ...,
more
Electrical Interface Wiring Diagram for Ford Kit C20002, Pacbrake Exhaust Brake Wiring Schematic.
Connect to Ford wire (red with green
tracer) using yellow T-tap connector. Gray
Wire Red Ignition Power Source Ground
White Green Yellow Blue Transmission
Solder Splice Cut Purple c/w yellow tracer
Solder ...,
more
1987 Ford Taurus System Wiring Diagrams, SYSTEM WIRING DIAGRAMS. Selected Block.
1987 Ford Taurus. 1987 System Wiring
Diagrams. Ford - Taurus. COOLING FAN.
Cooling Fan Circuit ...,
more
