INSTRUCTION MANUAL for DODGE SOLIDLUBE LM800 BEARINGS
Short summary:
INSTRUCTION MANUAL. for. DODGE. . SOLIDLUBE. . LM800 BEARINGS. Installation and Operation: ... be possible, but is advisable to obtain optimal service. ...
Long summary:
INSTRUCTION MANUAL for DODGE SOLIDLUBE LM800 BEARINGS Installation and Operation: Solid Film Lubrication: Solid film lubricating bearing material will transfer a film or coating of lubricant to the shaft as the shaft rotates. This film or coating prevents metal to metal contact between the shaft and bearing material, as the shaft actually rides upon the lubricant and not upon the bearing itself. Because it is a solid, the lubricant will not squeeze out when the shaft is not rotating, The bearing will not need additional lubrication since the solid lubricant is impregnated into the bushing material and is transferred or “worn” onto the rotating shaft at a rate determined by the rubbing speed of one material to the other and the imposed load. Since this is a “wear type” bushing, wear will be experienced under normal operating conditions. Installation: Shaft preparation: The bearing journal should not be exposed to grease, oils or dirt to insure good life of the bearing. NO OIL OR GREASE SHOULD BE USED ON THE BUSHING OR SHAFT WHEN ASSEMBLING THIS BEARING. The shaft should be clean and free of burrs and nicks. The shaft should be held to a minimum amount of taper and as little eccentricity as possible so a uniformly distributed rubbing surface can be maintained. For best results, the shaft finish should be held to 10 to 20 micro-inches and hardness should be 35 Baldor Electric Company “C” or higher. Shaft tolerance should be +.000/-.002 for commercial steel shafting. The LM800 bearing has a high coefficient of friction which can result in stalling when many bearings run off the same drive system. Please contact Baldor Electric Company for further information. Installation of LM800 Pillow Block Assembly: 1. Slide the assembled pillow block on the shaft. 2. Align the pillow block on the shaft and shim the base if necessary. Tighten the hold-down bolts. Running In: To improve life expectancy from this type of bearing, a brief run-i ...
Source: www.dodge-pt.com
Related
2006 Dodge Charger Feature Availability, 2006 DODGE CHARGER Interior SE SXT R/T Air
conditioning Manual temperature controls S
S S Automatic dual zone climate control
with infrared sensors and individual
driver/passenger settings (Convenience
Group ...,
more
Instruction Manual for DODGE Ball Bearing Injection Molded End Covers, Instruction Manual for DODGE. ®. Ball
Bearing Injection Molded End Covers.
Installation. (Series 204-212). 1.After
installation of bearing on shaft, ...,
more
SERVICE MANUAL 2004 RAM TRUCK 1500 - 2500 - 3500, Dodge, Dodge Truck, and Jeep vehicles,
Call (800) 890-4038 or ... The information
contained in this service manual has been
prepared for the professional ...,
more
