INSTRUCTION MANUAL FOR DODGE IEC ELECTRIC CLUTCHES
Short summary:
Electrical Code and all other applicable local codes. Wiring DODGE Power Supplies. are available with a wiring diagram showing the proper ...
Long summary:
The ratings of all motors in this catalog are based on continuous operation at 40
o
C ambient tempera-
ture and a maximum elevation of 3300 feet above sea level. For higher ambient temperatures or greater
installation heights, it is necessary to reduce the motor power rating per Diagram below. IEC Electric Clutches are preburnished at the factory and
should not require any air gap adjustments prior to
operation. IEC clutches are designed with DYNA-GAPâ ¢,
a self-adjusting feature that will automatically compensate
for friction surface wear. Armature air gaps should range
from .030 to.050 inches, which have been pre-set at the
factory. To ensure that drive is not unexpectedly started, turn off
and lock out or tag power source before proceeding.
Failure to observe these precautions could result in bodily
injury.
STEP 1 All parts should be examined for any damage
during the shipping and handling process. Measurements
should be taken to ensure parts meet application
requirements. All parts must be clean and free of any
foreign material before attempting assembly.
STEP 2 Mount drive component onto clutch. Mount
properly sized sheave, pulley, or sprocket onto the clutch Insert the key into the shaft. Keys should fit keyseat
with a tight fit on the sides and slight clearance over
the key.
B. Slide the preassembled IEC Clutch with mounted drive
component onto shaft and into the proper position.
Ensure drive component aligns with driven component.
Tighten set screws in the mounting collar to the
recommended tightening torques. (Self-locking set
screws are recommended.) See Chart 1.
Source: www.dodge-pt.com
Related
Files under this topic are not filed yet. Please use search bar to find other one
