Instruction Manual for DODGE Ball Bearing Injection Molded End Covers
Short summary:
Instruction Manual for DODGE. ®. Ball Bearing Injection Molded End Covers. Installation. (Series 204-212). 1.After installation of bearing on shaft, ...
Long summary:
Instruction Manual for DODGE ® Ball Bearing Injection Molded End Covers Installation (Series 204-212) 1.After installation of bearing on shaft, remove grease lubrication fitting with a 7 / 16 in. (11mm) socket or wrench. 2.Insert the lubrication fitting through the serrated washer provided in the poly bag. Place the raised small end toward the hex portion of the fitting. Reinsert the fitting into the bearing housing through the end cover mounting slot. The washer will be between the end cover slot and fitting. Make sure no dirt or debris gets into the fitting opening. 3.Hold cover firmly against face of bearing housing and tighten lubrication fitting with socket or wrench compressing both washer and end cover mounting tangs. Seating torque required is approximately 30 in.-lb. (34 kgf-cm or 340 N-cm). A tight compression and slight spreading of mounting tangs is normal and acceptable. 4.For non re-lube applications, part number 430020 hex head plug is available. Modifying End Cover to Allow for Thru or Extended Shafts 1.One or more grooves or groove guides can be found on the inside face of the end cover which will conform to shaft diameters equal to or greater than bearing bore sizes of that particular series. Prior to mounting, use a utility knife to score bottom of groove from inside of end cover to a diam- eter consistent with your shaft size (Ref. Figure 1). WARNING To ensure that drive is not unexpectedly started, turn off and lock out or tag power source before proceeding. Failure to observe these precau- tons could result in bodily injury. Note: For applications involving slight misalignment, DODGE recom- mends scoring the OD larger than the bore size of the bearing. 2.Knock out or press bore slug of end cover out. Note: ‘P’ style covers will only fit properly on shaft attachment side of pillow blocks. For thru-shafts, knock out slug and slide cover on shaft prior to installing shaft into bearing bore. WARNING: Because of t ...
Source: www.dodge-pt.com
Related
2006 Dodge Charger/Magnum Police Upfitter's Guide, 2006 Dodge Charger and Magnum Service
Manual for appropriate service procedures,
torques specications, component separation
clearances, and other standard information
that is common with the unmodied vehicle
...,
more
BD X-MONITOR DODGE Installation Manual, thermocouple lead to the male connector of
the thermocouple. Route the large yellow
covered wire toward the firewall taking
precaution to keep it away ...,
more
RAM 3500 CHASSIS CAB, NOISE PASS BY STANDARDS. HEAVY DUTY ENGINE
CERTIFICATION. SAFETY ... ELECTRICAL /
WIRING INFORMATION. OPTIONAL EQUIPMENT
WEIGHTS. OCCUPANT RESTRAINT SYSTEM ...,
more
