Dodge Viper Heat Shields
Short summary:
Dodge Viper Heat Shields. For 1992-1999 Roadster & 1996-1999 Coupe. Catalog 6700 Please study these instructions carefully before installing your new ...
Long summary:
Dodge Viper Heat Shields ©2006 Edelbrock Corporation Catalog 6700 of 2 Brochure 63-6700 Rev. 5/06 DA/mc Dodge Viper Heat Shields For 1992-1999 Roadster & 1996-1999 Coupe Catalog 6700 INSTALLATION INSTRUCTIONS Please study these instructions carefully before installing your new heat shield. If you have any questions, please contact our Technical Hotline at : 1-800-416-8628 from 7 am 5 pm, Monday through Friday, Pacific Standard Time or e-mail us at Edelbrock@Edelbrock.com. Please fill out and mail your warranty card. INSTALLATION INSTRUCTIONS WHEN BEING INSTALLED ON VEHICLES WITH EDELBROCK T.E.S. 66062: RIGHT SIDE: 1. Remove top of heater blower box from lower heater box assembly in engine compartment. 2. Remove the bolts from the coolant reservoir so it can be moved around. 3. Disconnect spark plug wires from spark plugs and move out of the way. 4. Loosen the 2nd and 4th upper header flange bolts for mounting bracket installation. 5. Install one mounting bracket on each of the two header flange bolts loosened in Step 4. Position the brackets so that the slot on the end is straight down under the bolt and bracket is flat on top. These brackets will angle forward and down slightly when installed properly. NOTE: Before attempting to install the heat shield onto the brackets, first measure the distance between the threaded holes in the mounting brackets. You should have 9 1/8 from center to center of holes. If you dont, you can bend the brackets with a pair of pliers or a small hammer. Doing this will make heat shield installation much easier. 6. Install the right side heat shield by angling the front edge of the heat shield down toward the front half of the header and slipping it forward between the header and the coolant reservoir and hose. Once it is down on top of the brackets, slide it toward the rear of the car, align holes and install supplied bolts and lock washers. NOTE: We recommend you use a small amount of high heat silicone R.T.V. on the top surface of the mounting bracket to help to keep the shield from rattling against the mounting brackets. 7. After you have tightened the heat shield to the mounting brackets, tap on the shield to see if you have rattles. To eliminate rattles, you can: (1) adjust the shield at the mounting points slotted holes, (2) bend the heat shield as needed for clearance, (3) bend mounting brackets slightly for a better fit on your vehicle. 8. Re-install plug wires onto spark plug. NOTE: Spark plug boots, wires and hose should not contact the sharp edges of the heat shield as they can be damaged ...
Source: www.edelbrock.com
Related
2006 Dodge Charger/Magnum Police Upfitter's Guide, 2006 Dodge Charger and Magnum Service
Manual for appropriate service procedures,
torques specications, component separation
clearances, and other standard information
that is common with the unmodied vehicle
...,
more
BD X-MONITOR DODGE Installation Manual, thermocouple lead to the male connector of
the thermocouple. Route the large yellow
covered wire toward the firewall taking
precaution to keep it away ...,
more
RAM 3500 CHASSIS CAB, NOISE PASS BY STANDARDS. HEAVY DUTY ENGINE
CERTIFICATION. SAFETY ... ELECTRICAL /
WIRING INFORMATION. OPTIONAL EQUIPMENT
WEIGHTS. OCCUPANT RESTRAINT SYSTEM ...,
more
