03 Mitsubishi Lancer Evolution 8 Front Control Arm Bushings
Short summary:
Installation instructions For set # 5.3133 03 Mitsubishi Lancer Evolution 8 Front Control Arm ... of work. It is also recommended that if you choose to do this work yourself that a factory service manual ...
Long summary:
Installation instructions
For set # 5.3133
03 Mitsubishi Lancer Evolution 8
Front Control Arm Bushings
It is recommended that if you are unfamiliar with this type of work that you refer to a qualified service center specializing in this type of work.
It is also recommended that if you choose to do this work yourself that a factory service manual be obtained for the proper procedures
pertaining to removal, replacement and proper torque specifications for your vehicle. This instruction sheet is intended as a guideline for the
safe installation of Energy Suspensions polyurethane bushings, once you have removed the factory suspension components from your
vehicle. Wheel alignment is almost always disturbed when suspension components are removed or replaced. It is recommended that you
have the alignment checked on your vehicle at a qualified alignment shop.
17404
6/OCT/03 BRH
Updated 8/JAN/03 BRH
2003 Energy Suspension. All rights reserved.
2003 Energy Suspension. All rights reserved.
C
C
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
1131 VIA CALLEJON, SAN CLEMENTE, CA 92673
R
Refer to the shop manual for the safe removal of front
control arm, torque specs, and alignment of your
vehicle.
DO NOT APPLY HEAT OR
BURN OUT RUBBER TO
REMOVE! DAMAGE TO
ALUMINUM CONTROL ARM
MAY RESULT.
1
I.D. of front horizontal position is Ø1.362". Using a hydraulic
press, properly support control arm and slowly push out the
rubber bushing with bonded outer metal casing. Remove all
sharp edges from I.D. Apply grease to all metal parts that will
contact the new polyurethane bushings.
2
O.D. Smaller than Ø1.362"
I.D. Bigger than Ø1.362"
I.D. Bigger than Ø2.990"
O.D. Smaller than Ø2.990"
I.D. of ...
Source: www.energysuspension.com
Related
2003 MITSUBISHI MONTERO SERVICE MANUAL, designed into this Mitsubishi vehicle.
This manual is designed for use with the
2003. MONTERO Service Manual Volume 1
Volume 3. Volume 4 and Volume 5 ...,
more
Installation Instructions Mitsubishi Eclipse Gen 1 & 2, ... COMPONENT IDENTIFICATION COMPONENT
IDENTIFICATION COMPONENT IDENTIFICATION
Mitsubishi Eclipse Big Brake Kit ...
Please read and understand the bed-in
procedures included with this manual. If
you have any ...,
more
2003 Mitsubishi Lancer Evolution 8, ECU Database Revised October 2, 2005
www.plxdevices.com (408)745-7591 2003
Mitsubishi Lancer Evolution 8 ECU ... Use
these documents as guidelines ONLY and
refer to your vehicles service manual for
detailed ...,
more
